ZEPRO ZR 10/15

Introducing ZEPRO ZR 10/15, the new tuck-away lift for installation on box bodies or semi-trailers.
Lifting capacity of 1000 and 1500 kg.

ZR 10/15 is the robust tuck-away lift for flexible distribution. Easily accessible when you need it for loading and off-loading; tucked neatly out of your way when working at fixed loading docks.
Available with 1 arm length allowing lifting heights up to 1350 mm.

- The compact design makes it easy to install and fits most vehicles.
- Two cylinder design and a light weight construction with maximum stability.
- Easy to use with two button function.
- Trolley stops as standard.
- Service friendly with few maintenance points, easy to access.

×

Manual controler with a spiral cable

Manual control with grip-friendly design and magnetic mount. The control has a lock that locks the other controls when not in use.

Previous Next
×

Rollstops

If you have loads on wheels, the built-in rollerstops provides effective protection for both goods and employees.

Previous Next
×

Additional control unit

Additional control units are available in several versions for fixed installation, spiral cable or radio control.

Previous Next
×

Radio control unit

Compact and simple to install.

Previous Next
×

Side loading ramps

Possibility to load from the platform side even from docks and pavements. Available in aluminium in several sizes.

Previous Next
×

Drive over locks

In normal use a platform should never be overloaded and the operator should always refer to the ZEPRO loading diagram for his lift. If it is necessary to use the platform as a forklift bridge to the loading dock, special drive over locks must be installed. These locks can take up to 3 tons total loading (forklift plus goods) and are attached to the truck and pulled out when required. The locks take the load off the tail lift cylinders and give you even greater flxibilty when using your ZEPRO lift.

Previous Next
×

Platform access ladder

Platform access ladder is a neat fold out ladder attached to the platform inside a thin holder. It provides quick access to the inside of the vehicle body without the necessity of lowering the tail lift platform.

Previous Next
×

Warning set

During loading and unloading, you want to be visible, and you don’t want people to park in the area where you are working. Warning flags and signs get worn out by the weather, by dirt and cleaning. Be sure to replace them in good time, so you are always visible when working with your tail lift. Our warning sets contain flags to make sure your tail lift is as visible as possible, even when folded down, signs to demarcate your working area and prevent others from parking too close by, and yellow reflector tape (in line with the ECE R48 directive) to mark the side of the bridge, acting as an extension of the vehicle's side contour markings.

Previous Next
×

Warning lights

To increase the safety of loading and unloading warning lights can be mounted on the lift. Activated automatically when the platform is lowered to a horizontal position.

Previous Next

ZEPRO ZR 10/15 specifications

Technical infoZEPRO ZR 10-135 ZEPRO ZR 15-135
Lift Height (mm)1350 mm1350 mm
Platform Length (mm)1055 - 1440 mm1055 - 1440 mm
Platform Width (mm)2200 - 2600 mm2200 - 2600 mm
Lifting Capacity (kg)1000 kg1500 kg
Alu platform
Steel platform
Alu/alu platform
Steel/alu platform
Contact us

Din sökning på "" gav träffar.

Searching

×
×